CVE-2026-79976
NULL pointer dereference in the MCTP I2C+GPIO target binding triggerable by a peer I2C controller
- High 7.1
Description
The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes. The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop(). A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP. The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet. The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped. The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC). On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed. The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected.
Key facts
- Published
- 21 Oct 2026
- Last changed
- 4 Nov 2026
- Assigned by
- zephyr
- EPSS
- 0.29% likely to be exploited in the next 30 days, higher than 21.816% of CVEs (scores for 17 Nov 2026)
- SSVC (CISA)
- Exploitation: none; Automatable: no; Technical impact: partial
Severity scores
Each score is shown as its source gave it. They are not averaged or merged.
- 7.1CVSS 3.1, Highfrom the CNA (zephyr)
CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:L/I:N/A:H
Historical context and remediation
This reference retains the original CVE publication date. A recent record update does not mean a new attack occurred.
No separately sourced impact summary is available on this page yet. Consult the description, version data and dated exploitation evidence.
No explicit remediation statement is available on this page yet. Consult the original record and vendor references before choosing a fix.
Version statuses below come from the CNA. An “unaffected” version is not necessarily a currently supported release or proof of a patch date. EPSS is a dated risk estimate, not a count of historical attacks.
Affected products
| Vendor | Product | Versions |
|---|---|---|
| zephyrproject | zephyr |
|
Timeline
- 21 Oct 2026 Published