CVE-2026-87042

Zephyr PTP: unvalidated Delay_Resp message interval lets an on-link peer wedge the PTP thread and flood the network

  • Medium 6.5

Description

The IEEE 1588 (PTP) port implementation in subsys/net/lib/ptp/port.c adopted the logMessageInterval field of a received Delay_Resp message without any validation. port_delay_resp_msg_process() stored the raw wire value (a full-range int8_t) into port_ds.log_min_delay_req_interval, and that value is later used as a shift count by port_timer_set_timeout() when the Delay_Req timer is armed. Values below about -30 truncate the computed timeout to zero, and values with a magnitude of 64 or more perform an undefined shift of a uint64_t; the standards-defined "not applicable" encoding 0x7F fell into the latter case as well. PTP messages are received over unauthenticated link-local traffic (UDP multicast on 224.0.1.129, IPv6 multicast, or raw IEEE 802.3), and the handler accepts a Delay_Resp from any sender as long as the port is a time receiver using the end-to-end delay mechanism and the message echoes the port identity and a pending sequence id — both of which the victim itself broadcasts in its Delay_Req. Any node on the same link can therefore inject a single crafted Delay_Resp, or simply become the time transmitter and advertise the bogus interval. Once the delay timer is armed with a zero timeout, the cooperative PTP thread re-arms and retransmits a Delay_Req on every tick. Each transmission takes a buffer from the fixed CONFIG_PTP_MSG_POLL_SIZE message slab (default 10) and holds it on port->delay_req_list for three seconds, so the slab is emptied within milliseconds and ptp_msg_alloc() then blocks with K_FOREVER inside the only thread that frees those buffers — permanently stalling time synchronization until reboot. Where a transmit-timestamp callback on another thread keeps recycling buffers, the result is instead a sustained multicast Delay_Req flood and continuous CPU consumption. There is no memory corruption and no disclosure of data; the impact is availability of the PTP subsystem and of the local network segment. The fix rejects intervals outside a representable range and treats 0x7F as "not applicable" as required by IEEE 1588-2019 Table 42. The equivalent unchecked adoption of logMessageInterval from Sync messages in port_sync_msg_process(), a weaker variant of the same issue, is fixed by the companion change 334bf57f416f (#118150), which applies the same range check, ignores the field for unicast Sync messages and treats 0x7F as not applicable.

Key facts

Published
10 Nov 2026
Last changed
13 Nov 2026
Assigned by
zephyr
EPSS
0.312% likely to be exploited in the next 30 days, higher than 24.439% of CVEs (scores for 15 Nov 2026)
SSVC (CISA)
Exploitation: none; Automatable: no; Technical impact: partial

Severity scores

Each score is shown as its source gave it. They are not averaged or merged.

  • 6.5CVSS 3.1, Mediumfrom the CNA (zephyr)CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H

Historical context and remediation

This reference retains the original CVE publication date. A recent record update does not mean a new attack occurred.

No separately sourced impact summary is available on this page yet. Consult the description, version data and dated exploitation evidence.

No explicit remediation statement is available on this page yet. Consult the original record and vendor references before choosing a fix.

Version statuses below come from the CNA. An “unaffected” version is not necessarily a currently supported release or proof of a patch date. EPSS is a dated risk estimate, not a count of historical attacks.

Read the original CVE record.

Affected products

VendorProductVersions
zephyrprojectzephyr
  • Default status: unaffected
  • 3.7.0 up to but excluding 4.3.2 (affected)
  • 4.4.0 up to but excluding 4.5.0 (affected)

Timeline

  1. 10 Nov 2026 Published

Weakness

References